Basic Poker Scanning Camera Techniques

Basic Poker Scanning Camera Techniques

Just about the Accessories and cards you need can be found in craft stores such as cards with apertures but it is still best to understand how to cut your own. You might want a design or style that cannot be achieved without a few cuts or alterations so these simple card making techniques can be invaluable when it comes to creating your cards look professional. If you cut a line that is not quite straight then you will notice it and so will your customers, you will need to be professional about everything.

Scoring then folding

If your card or paper needs to be folded then it is advantageous to evaluate the line first to offer you a professional finish to your own springs and click here markedcardsshop.com to get more details.

  • Switch over your work Therefore the exterior is facing down then indicate where the score line is to be with two pen marks.
  • Then line up your metal ruler with the marks. For those who have not obtained a scoring instrument then use a blunt point to evaluate your own lines. An item like an empty ballpoint pen will work well to draw the line so you can see an indent from the paper.
  • You then will need to fold the card or paper with both hands and press it down firmly. If at all possible use the side edge of a bone folder to press on the edge firmly.poker

Cutting

You want to use the Right tools to have a clean expert cut. The craft knife you select should be sharp and you will need a flat clear surface to work with a flat metal ruler.

  • Mark where you need to cut the paper of card with three or two pen marks, depending upon the size.
  • You then will need to line up the metal ruler with your poker scanning camera. Hold the ruler firmly in place, this is a lot easier to do position, and then draw the knife along the line towards you.

Tearing

If You Wish to add a Little more depth and character to your work then you might want to tear your paper as opposed to cut it with a knife.

  • To acquire a relatively the grain you have to tear over.
  • If you would like to have an irregular tear then only go against the grain.
  • Aperture Cutting
  • Mark out the Aperture required with a pencil, ruler and set square.
  • Lineup a metal ruler and then cut on the first line with a sharp craft knife always set the ruler over the piece you are keeping.
  • Repeat the procedure on the opposite sides ensuring that you only cut where you need no and to.
  • When you have finished your cutting on the middle section should only fall away. Should it not the always cut the additional pieces and never tear them as this provides a poor finish.

 

 

 

It's only fair to share...Share on Facebook
Facebook
Tweet about this on Twitter
Twitter
Share on LinkedIn
Linkedin